RAQCOP = IPCop + Cobalt Raq, Cobalt Raq Firewall Applicance Software, Velociraptor Software Upgrade.

raqcop.com > Installation > Raq3 and Raq4 > USB Port on a Velociraptor

Pages: [1]

« previous next »

Author

Topic: USB Port on a Velociraptor (Read 1060 times)

noxin

Newbie

Posts: 1

USB Port on a Velociraptor

« on: September 28, 2008, 02:34:45 PM »

Hey all,
I read in another post that adding a usb port to a velociraptor is as simple as soldering on the appropriate jack.

Can anyone confirm that's the case and has anyone actually done it? Pictures available?

Thanks a bunch!

--Pat


	Logged

Davesworld

Administrator
Sr. Member

Posts: 282

I'm the same Dave who patches and compiles raqcop.

Re: USB Port on a Velociraptor

« Reply #1 on: October 17, 2008, 03:56:27 AM »

Sorry about the lag in response here.

Hadn't done it yet so I have no proof. I need to get the surface mount resistor and capacitor value as well as the jack itself. I have some time, I'll look into it. The only reason Symantec even put a pci slot in was to be able to put two more ethernet ports in it or they would have omitted that too. I too want my usb ports on my two raptors, it makes backups much easier.


	Logged

Main Daily Firewall: Cobalt Raq 4i modded to use a low voltage K6-III 1.8v 256k cache 500mhz clocked at 550mhz, VFD display. Raqcop 1.4.21

Others: One additional 4i for development left stock and two Symantec Velociraptor 500's with the 550mhz low voltage processor mod. Raq550, Two Raq XTR units